Turbine Replacement – $129
- Replace old ball bearings with new ceramic ball bearings
- Install balanced turbine assembly with hardened chuck bur gripping mechanism for extended life
- Replace old o-rings with new high temperature concentric o-rings
- Test speed, concentricity, and DB (noise level) testing
- Clean the internal and external dental handpiece housing
Un-Clog Water Line – $35
- Thread a wire through the water line and chip air line
- Connect the handpiece to the water line cleaner
- Purge the water line using the plunger
- Test dental handpiece spray and mist
Bur Removal – $35
- Disassemble turbine or handpiece
- Remove the bur from the chuck using a small punch
- Clean the interior of the head and back cap
- Change the turbine o-rings
- Install the turbine back into the dental handpiece
- Test speed, concentricity, and DB (noise level)
Clean, Lubricate, and Test – $35
- If the handpiece does not need a full repair, we will clean the critical components (interior and exterior) and then lubricate and test the motor to ensure the motor runs to the manufacturer's specifications
Head Reattachment – $125
- Disassemble head, water lines, air lines and fiber-optics
- Clean the head and neck of oil and debris
- Change body o-rings and neck o-rings
- Braze or loctite head back into place (24-hours cure time)
- Re-assemble water and air lines to the manifold
- Test speed, concentricity and DB (noise level) testing
Re-Threading of Back End – $80
- Remove old threading from the rear of the handpiece
- Smooth the surface of the rear of the handpiece
- Install collar for reaming of new threads
- Machine re-thread the back-end to standard threading specifications
Signs a High Speed Handpiece Needs Repair
- Back cap getting hot
- Back cap does not have spring
- Lack of torque, squealing, wobbling
- No water or water leaking
- Not holding a bur or locking burs
- Vibration or wobble while in use
- Water not spraying in a mist